Q. What is a Combustion Catalyst System? A.
The Combustion Catalyst System (CCS) is a scientifically
developed catalyst system which injects platinum into the
engine through the air intake of a naturally aspirated or
turbo charged engine. The catalyst enables a more complete
burn of the fuel in the combustion chamber during the power
stroke. A more complete burn in the power stroke enables the
engine to run more efficiently.
Q. Is the CCS
system a fuel additive? A. The CCS system injects the
catalyst into the air stream through the air intake. It is not
mixed with the fuel and is not a fuel additive. Once in the
combustion chamber, the air, catalyst and fuel are blended to
optimize combustion where it is most important.
Q.
Will the CCS products void my engine warranty? A.
Installing an after market product will not void a vehicle’s
warranty. If however, the after-market product were proven to
be the cause of engine or component damage, this damage would
not be covered under warranty and would be the responsibility
of the after-market manufacturer. This applies to all non
Original Equipment Manufacture (OEM) after-market products
such as oil filters, starters, fuel filters and the CCS
system. For more information see the Code of Federal
Regulations for the Magnuson-Moss Warranty Act (cite:
16CFR700.10 – Sec. 700.10 Sec. 102 (c))
Q. How do I
know what system to use for my equipment? A. To
determine which CCS system you need, you will need to know
what the engine’s maximum rated fuel consumption rate. It is
important to note that it is not based on your average fuel
consumption, but the maximum rated consumption from the engine
manufacture. For example: If you are operating a bulldozer
that is rated up to 16 gallons per hour, you will need one
DC-100 unit because this system will handle engines that
consume up to 18 gallons per hour. For a full break down on
available products, please see the Products tab.
Q.
What is the proper disposal for the spent catalyst
solution? A. Neither the catalyst solution nor any of
its components are regulated as hazardous waste by the EPA.
Therefore, disposal should follow local regulations for
non-hazardous materials. A simple rule to follow could be to
dispose under the same parameters as your antifreeze.
Q. Are Material Safety Data Sheets (MSDS) and
toxicology data available for the Combustion Catalyst System
liquid? A. Emissions Technology maintains an MSDS for
each product. In addition, NIOSH publishes toxicology profiles
for certain chemicals. MSDS reports are attached to all
packing slips during shipping. For an electronic version,
please contact Emissions Technology directly to obtain this
report.
Q. What is potential for long-term exposure
to the CCS liquid product under normal service? A. As
shown on the MSDS, the individual components of the liquid
product are of low toxicity. Furthermore, the liquid product
is packaged in a sealed bottle designed for installation
without contact with the liquid. Under normal use, you install
the unit without opening the bottle which leads to extremely
low potential for exposure. Since health risk is a product of
toxicity and exposure, the health risk of installing and using
this product is extremely low, and much less than other engine
fluids handled. To minimize health risk, please follow the
handling precautions listed in the MSDS.
Q. What
happens if I forget to add the replenishment catalyst after
400 hours of operation? A. If a replacement bottle of
catalyst is not connected, the properties of the catalyst
material that was consumed over the 400 hours of operation
will slowly deteriorate causing the engine to go back to its
original baseline levels of exhaust emissions, fuel
consumption, oil contamination and horsepower. This will not
cause any harm to the engine, just the benefits from the
catalyst will be gone. Once a replacement bottle is installed,
the engine will revert back to the previous benefit levels
achieved. Maximum benefits will be achieved if the 400 hour
change interval is followed.
Q. If my preventative
maintenance schedule is at 300 hours, can I replace the
catalyst at this time? A. The catalyst is designed to
last 400 hours. If this does not match your maintenance
schedule, it would not harm the system or your engine to
change out the catalyst while your equipment is being
serviced. After 400 hours, the operating benefits from the
catalyst will diminish.
Q. Where can I buy a
Combustion Catalyst System? A. The CCS systems are only
sold through authorized distributors. To find a distributor in
your area, please contact customer service at 602-288-0111 or
info@emissionstech.com.
